sec蓄电池安装维护注意事项

铅酸蓄电池在安装和维护时需要小心。不安全安装或

维护程序可能导致重伤或死亡。触电或烧伤、酸中毒

如果不遵守适当的安全预防措施，可能会导致烧伤和火灾。

以下注意事项适用于所有蓄电池安装和维护工作。更多

有关详细信息，请参阅以下部分。

-在尝试安装、拆卸或执行维护工作之前，请断开所有电源。

充电时必须测量浮充电压，尤其要小心，因为短路

此时的电池不仅会造成人身伤害，还会导致严重的设备故障。

-不要损坏电池的任何部件，包括盖子、通风口、端子盖等。

-保持电池清洁干燥。使用½ 在4升水中加入1公斤小苏打，以中和

可能是酸。不要在电池的任何部位使用清洁剂或溶剂。不允许

蓄电池或电缆上积聚的灰尘过多。

-保持蓄电池接头清洁、润滑和紧固。连接松动会减少

电池待机时间，导致电池起火。

Lead acid batteries require care in installation and maintenance. Unsafe installation or

maintenance procedures can cause severe injury or death. Electrical shock or burns, acid

burns and fire can result if proper safety precautions are not followed.

The following precautions apply to all battery installation and maintenance work. For more

information, see the following sections.

- Disconnect all power before attempting to install, remove or perform maintenance work.

When on-charge float voltages must be measured, be particularly careful because shorting a

battery at this time can cause not only personal injury, but severe equipment failure as well.

- Do not tamper with any parts of the battery including cover, vents, terminal covers, etc.

- Keep batteries clean and dry. Use ½ kg of baking soda in 4 liters of water to neutralize any

possible acid. Do not use cleaners or solvents on any part of the battery. Do not allow

excessive dust to accumulate on the battery or cabling.

- Keep battery connectors clean, greased and tight. A loose connection can reduce

battery standby time and cause battery fires.